Post by Mike C on Aug 25, 2014 10:10:11 GMT
Somewhere on this board I have seen a thread on awning light covers, but I can't find it.
Our awning light had no cover, so we took it off, restored it and bought 'Crown Light Spare Cover' part V724 from Crusader. This is far too big, so we put the Safari lamp inside it and drew around it. Then we cut (with a junior hacksaw) another two, or three mill off the cover again. The cover now fits, but instead of being screwed onto the outside of the seal, we have tucked it under the seal to hold it in place. So far, so good, but we will have to wait and see if this is the perfect job!
Regards
Mike
Our awning light had no cover, so we took it off, restored it and bought 'Crown Light Spare Cover' part V724 from Crusader. This is far too big, so we put the Safari lamp inside it and drew around it. Then we cut (with a junior hacksaw) another two, or three mill off the cover again. The cover now fits, but instead of being screwed onto the outside of the seal, we have tucked it under the seal to hold it in place. So far, so good, but we will have to wait and see if this is the perfect job!
Regards
Mike